This console is suitable for mounting Ronja onto a wall or a horizontal concrete or masonry surface. The direction of the beam may be from perpendicular to nearly parallel to the wall. Works with any beam direction when mounted on a horizontal surface.
The console consists of two identical pieces, one for RX and one for TX. It can be used also for beam completely parallel to the wall, but the pieces must be then mounted above each other.
Each piece is mounted by four screws into plugs into the wall. Eight holes must be drilled in total to mount one Ronja using this holder.
The interface are two square flanges in arbitrary mutual position on a flat surface of masonry or concrete. Each flange has got four 12mm holes with plastic plugs in the masonry placed in corners of 100mm square. A 140mm square place is occupied by each flange. The wall must be masonry. Wooden board or beam wall is not permitted. Plastic foam insulation must be removed. Bricks or plaster must not crumble. The interfaced building must not sway in wind or twist from thermal expansion comparably with the beam divergence.
Contact, support: Clock
on the Internet Relay Chat.© 1998-2016 Karel ‘Clock’ Kulhavý et al..