Material needed for Ronja Wall Parallel Console
Where do I get the material?
Steelworks
Sections
- 1pc. 900mm of 50x50x2mm hollow steel square section
- 1pc. 311.1mm of 25x25x1.5mm hollow steel square section
- 1pc. 220mm of 25x25x1.5mm hollow steel square section
- 2pc. 152.7mm of 25x25x1.5mm hollow steel square section
- 2pc. 108mm of 25x25x1.5mm hollow steel square section
- Total amount of the 25x25x1.5 is 1.1m
- 3pc. 40mm of 40x40x4 steel L section
Nuts and bolts
- 9pcs. bolt M8x12+8-2, galvanized, Allen head
- 2pcs. bolt M10x50+20-5, with max. 25mm unthreaded, galvanized, hex or Allen head
- 3pcs. bolt 8mm dia. for 12mm wall plug, hex or Allen head
- 1pc. nut M8, galvanized
- 2pcs. nut M10, galvanized
- 9pcs. toothed spring washer M8 (8.4mm), galvanized
- 2pcs. toothed spring washer M10 (10.5mm), galvanized
- 3pcs. plastic wall plug, 12mm hole dia.
Ironmonger's
- Rough emery paper for grinding off rust and excess paint
(if you are not using industrial zinc bath or powder coating)
Chemistry
Applies only if you are not using industrial coating.
- Primer paint, anti-corrosive, outdoor, any colour, water-soluble
- Top paint, white colour, water-soluble
- Detergent and hot water for removing fat
Electrician
- Flat lightning rod clamp for clamping wire to 8.5mm hole
- Lightning rod clamp wire/wire or plate/wire (depends on available
grounding point)
- Lightning rod conductor. Length given by distance to nearest lightning
drain.
Contact, support: Clock
on the Internet Relay Chat.© 1998-2016 Karel ‘Clock’ Kulhavý et al..