Mounting Ronja Wall Corner Console

Choose suitable place so that:

300mm horizontally x 50mm vertically rectangular space neighbouring with the corner must be clear
Three 12mm holes can be drilled in the wall in a line, centered within the rectangular space, two neighbouring holes's centres 100mm apart.
The flange will sit flat and will not sit on cracking protrusions
The holes will not be between bricks or on edges of any disparities
There will be enough space to mount the optical heads in the required direction, for cables

Drill the 12mm holes in the wall, using the 12mm masonry drill. The centres of the holes will form a horizontal line. The first hole will be 50mm from the corner and the following in 100mm pitch. Put the console on the wall, with opening towards the wall (will sit only on two edges). Attach each hole of the console using the 8mm bolt with M8 (8.4mm) washer. Tighten down firmly.

Ground the console using the lightning rod clamps and lightning rod conductor to a suitable lightning conductor or grounded roof tin nearby. Check with a multimeter that the connection has resistance < 0.2 Ohm.

It is recommended to retighten the screws again after some settling time.