Ronja Twibright Labs

Building Ronja Wall Corner Console

Drawing
Postscript / PDF / EPS / BIG png / DXF (qcad)

Drilling

Drill the holes into the section.
Banging U section's edges

Hammering

Bang the U section with a big hammer along the edges to bulge them out to cancel out possible convexity of the central side of the U.

Painting

Paint the steel section. Install the two M10 bolts with M10 nuts and spring washers into holes in the side of the U section. Put bolt heads outside, square wedge washers inside, toothed spring washers over them and M10 nuts over them. Do not tighten the M10 nuts. The M10 bolts are for inter the universal holder.

-ne
3d/corner [0] -ne 3d/corner [1] -ne 3d/corner [2] -ne
3d/corner [3] -ne 3d/corner [4] -ne

Completion

Put the console together in the way shown in the model.

An expected information missing here?